Commonwealth Aircraft CA-27 Avon Sabre

In the late 1940's the Royal Australian Air Force began searching for a succesor to its first front line jet aircraft, the Meteor and Vampire.  The North American F-86 Sabre fit the RAAF's needs well, but a more powerful engine and armament was required. A decision was made to produce a modified F-86F at CAC using the Rolls Royce Avon turbojet in place of the usual General Elelctric J-34.  Since the Avon was shorter, lighter, but larger in diameter than the engine it replaced, and with the replacement of the six 0.50" machine gun armament with two 30mm cannon, the fuselage was greatly modified; so much so that only 40% of the structure is common to the original aircraft. Service testing began at the end of 1954, with full serveice commencing in early 1956.

Three series of Avon Sabres were built, Mark 30 aircraft had the original slatted wing and Mark 31 aircraft had the extended hard wing, while many Mark 30's were updated with the newer wing.  The definitive Mark 32 version used Australian built Avon 26 engines and the 6-3 wing, and were fitted (or retrofitted) to use the Sidewinder missile.

The aircraft photographed for the walkaround (A94-914) is a Mark 30 fitted with the hard wing. 

The CAC Avon Sabre was  replaced in RAAF use by the Mirage, with sixteen surplus aircraft going to Malaysia where they served successfully until replacement in the early 1980's.

The aircraft pictured is in the collection of
Australian Aviation Heritage Museum

557 Stuart Highway
Winnellie, NT 0820
AUSTRALIA

These photos were taken by Shane Weier

at the  Australian Aviation Heritage Museum

(click on the images below to load the full size photo)

(use your back button to return to this page after viewing full size photo)

Port side of cockpit area of fuselage, showin the squadron insignia Aft fuselage, viewed from the front Fore fuselage, viewed from the rear Vents on belly of aircraft

 

view of canopy port side gun fairing port side gun fairing nosegear assembly

 

airbrake assembly flap on port side of a/c fuselage area, between the wing, and stab engine exhaust pipe, viewed from port rear of aircraft

 

 tail of aircraft, viewed from port side port main landing gear  starboard flap  overall view of starboard side of aircraft

 

 This detail shot of the wing root shows the small root fairing which I believe is made of fibreglass.  It's actually a glossy pale blue colour identical to the top section of the fin, and not white as the reflections in the photo make part of it appear  Starboard side of aircraft, area between the wing, and horizontal stabs exhaust pipe, port side of aircraft