A bit of
research info:
I do not
remember where I read that during the Iran-Iraq War at least one of Iran's
F-14 was shot down by an Iraqi Mirage F1. That really inspired me. But
later I learned that was the exception not the rule, as F-14 fared better
in air-to-air combat.
It's not easy
to get information from that war. There are too many rumors and many
statements exagerate the results. From what I read and the photos I saw I
determined that Iraq received at least three variants of the Mirage F1.
One for maritime operations (painted in a two tone scheme with the top
color being a bluish gray), one for training (double seater) and one for
interception. The last one was later tasked with maritime attack because
of the F-14 greater capabilities in air-to-air combat.
The plane
depicted here is one of those fighters turned to anti-shipping duties.
These lacked the laser range-finder, had an extra antenna in the form of
an extended tail fin and I found no photos where they sported the
in-flight refueling probe.
In the
unfortunate USS Stark incident Iraqi officials stated that a single Mirage
F1 had fired both missiles. So I let my imagination fly a bit and pictured
these planes operated with two exocets, two magic aam and a drop tank and
that's what I tried to model.
Click on
images below to see larger images
The kit:
As far as I
know this is the only offering with inscribed panels for this jet. Airfix,
Heller and Hasegawa kits have raised detail and that's important for a
lazy modeler like me. In my opinion the next best kit would be Hasegawa's
and Heller would be the worst but it's also the one with the most
extensive decal sheet.
Kit is good, especially considering is 20+ years old. Fit is ok but not great, there's
little detail inside the cockpit but I'm more concerned with the outside.
It came with a single exocet, two drop tanks, the in-flight refueling
probe, laser range-finder and decals for South Africa, Jordan and Iraq.
I added the
wing tip rails from a Heller F1 and the fin extension from a plastic card.
Exocets came from an italeri missile set and the magics from Academy's
Super Etendard kit. I wanted to add a centerline drop tank, but it did not
fit. Either the tank is to large or the landing gear to short because I've
seen photos where they use those drop tanks on either the wings pylons or
the centerline pylon. Oh, and I also added seat belts from scratch.
Decals are the
ones from the kit, they were a bit yellowish but worked out great. I
positioned them as some photos show instead as how the instructions show.
I used vallejo air paints. I tried to match the colors from reference
photos and the shape from one of my references. This was the first time I
did a freehand camo over a plane (I once tried with a tank and blew it)
and I'm very happy about the result although it was not perfect.
In the end I
really enjoyed this quick project and was amazed at how small it is when
compared with some others modern fighters. I salute you, from Mexico,
fellow modelers.
Carlos
|